Filter
Top Products
YML749Rev1 V100 User Guide
www.netcomm.com.au 21
Phone Configuration
User Name: Your VoIP phone number. Your VoIP provider will assign you
this number. If you are not with a VoIP provider, this number is a
self-defined number in Peer-to-Peer call mode. (Refer to the
section on Telephone Book Tab for instructions. )
Display Name: What the called party sees when you call them.
Codec: G.729 is a high compression codec which only occupies 8kbits/
sec, whereas G.711 alaw and G.711 ulaw require 64kbits/sec. We
highly recommend you use G.729 instead of G.711 alaw/ulaw.
Default: G.729.
DTMF: Default: In-band.
Proxy and Registrar
Proxy / Registrar Info: The IP address of the SIP server on the Internet. The proxy server
is responsible for forwarding requests received from the V100
ATA to your VoIP service provider.
Port No.: The port on the SIP server that receives requests from the V100
ATA. Default: 5060.
Domain Info: The registrar that saves information of where a party can be
found.
Auth User Name: The authentication username assigned by your VoIP service
provider. This can be different to your VoIP number.
Auth Password: The authentication password assigned by your VoIP service
provider.
Expire: This is a duration of interval for SIP keep alive registration.
Default: 60.
Qvalue: The priority assigned to the V100 ATA to register on the SIP
server of your VoIP service provider. The value must be between
0 and 1 with 1 having the highest priority. Default: 0.8.