Filter
Top Products
V100 User Guide YML749Rev1
16 www.netcomm.com.au
Using the V100 ATA Configuration Utility
Once the V100 ATA Configuration Utility has been installed you will see the following window:
Status Tab
VoIP Phone Number: Your VoIP provider will assign a number. If you are intending to
use the V100 ATA in an IP to IP mode (commonly known as
Peer-to-Peer) you must configure the V100 ATA with the correct
settings. Please refer to the section on Telephone Book Tab for
further instructions.
Status: Indicates whether you have registered with the SIP server of
your VoIP service provider.
Connection Mode: PPPoE / DHCP / Fixed IP - The V100 ATA is setup as a DHCP
client by default.
IP Address: The IP address of the V100 ATA. If you have a DHCP server
running on your modem/router, the address indicated has been
assigned by this service. If you use a Fixed IP Connection Mode
this address is manually set by you.
Subnet Mask: The subnet mask of the V100 ATA.
Default Gateway: The gateway's address through which the V100 ATA communi-
cates with the Internet. This is usually your modem / router.