Filter
Top Products
[ 6 ] Getting Started
B. Install the Rechargeable Battery Pack into the Handset
The handset is powered by a rechargeable battery pack. The battery recharges
automatically when the handset is placed in the base unit. To maximize the charge capacity
of your battery pack, DO NOT plug the telephone cord into the base unit and wall jack
until the battery is fully charged.
1) Press down on the handset battery case cover (use the finger indention for
a better grip) and slide the cover downward to remove.
2) Turn the battery pack so that the connector with the red and black wires is
near the jack inside the battery compartment. Match the connector's wire
colors to the polarity label in the battery compartment (the connector
notches fit into the grooves of the jack only one way). Push the battery
pack connector into the jack until it clicks into place.
3) Make sure you have a good connection by gently pulling on the battery
wires. If the connection is secure, the battery jack will remain in place.
4) Place the battery case cover back on the handset and slide it upwards until
it clicks into place.
note
• Use only the NEC rechargeable battery pack supplied with your cordless telephone.
• Replacement battery packs are also available. Contact your NEC Representative.