Filter
Top Products
26
2.2 [quit]
Type quit will quit the Micronet SP5052A/S / SP5054A/S Gateway
configuration mode. And turn back to login prompt.
---------------------------------------------------------------
usr/config$ quit
Disconnecting...
login:
---------------------------------------------------------------
Note: It is recommended that type the “quit” command before you leave the
console. If so, Micronet SP5052A/S / SP5054A/S Gateway will ask
password again when next user connects to console port.
2.3 [debug]
Open debug message will show up specific information while Micronet
SP5052A/S / SP5054A/S Gateway is in operation. After executing the
debug command, it should execute command debug -open as well. One
example is demonstrated below.
Debug message information and configuration
---------------------------------------------------------------
usr/config$ debug
Debug message information and configuration
Usage:
debug [-add type1 [[type2]...]] | -open | -close | -status
-status Display the enabled debug flags.
-add Add debug flag.
-delete Remove specified debug flag.
-open Start to show debug messages.
-close Stop showing debug messages.
Example:
debug -add sip fsm
debug -add vp
debug -open
---------------------------------------------------------------
Parameters Usage:
-status Display the enabled debug flags.
-add Add debug flag.