Filter
Top Products
(Figure 9)
Telephone Modular
Jack
Plug
9VDC Adapter Jack
AC Wall Outlet
9VDC Adapter
Line Cord
HANDSET BATTERY INSTALLATION
CAUTION:
Use only the Nickel Cadmium (Ni-Cd) battery type included with this unit. Use of other
battery types may cause injuries or damage.
1. Remove the battery compartment cover of the handset.
2. Connect the rechargeable Ni-Cd battery as shown on Figure 10.
Handset
Battery
Compartment
RED Wire
BLACK Wire
Insert the End of the
Battery Pack Wire
(Figure 10)
3. Insert the Ni-Cd battery into the battery compartment of the handset.
4. Slide the battery compartment cover firmly in its closed position.
INITIAL SETUP
Before you can use your cordless telephone, the handset must be charged for at least 20
hours. See charging instruction in the MAXIMIZING BATTERY LIFE section of this manual.
TONE / PULSE SETTING
Select the appropriate dialing service by moving the T / P
(Tone / Pulse) switch on the bottom of the base unit:
••
••
• (T) TONE for Tone service, or
••
••
• (P) PULSE for Rotary service.
SETTING THE HANDSET RINGER ON / OFF
The handset ringer must be set to ring ON position in order to ring when receiving an
incoming call. See PROGRAMMING MODE section on page 20.
(Figure 11)
T / P
12