Filter
Top Products
IPLDK-20 Installation Manual Starting the IP LDK-20 System
72
6.2.3.4 FLEXIBLE NUMBERING PLAN (PGM 105)
PROCEDURE
To set your flexible numbering plan, perform the following Steps:
2. Press [Trans/PGM] + 105, then enter the station range (dial start and end station numbers).
Press [HOLD/SAVE] to accept change
Numbering Plan Detail
STATION NUMBERS DESCRIPTION
000 001 002 003
100 101 102 103
[TRANS/PGM] + 105
000 001 002 003
100 101 102 103
Station Number Assign. You will see the 4 station numbers corresponding to the 4 port
numbers. Station number length is in the range of 2 digits through 4 digits. There are
two methods for changing station number.
Dial two station numbers - Range start station number & range end station number,
then LCD shows dialed range value. Press the [HOLD/SAVE] button, then station
numbers changed from the first station number on current LCD to range end (All LEDs
of BTNs are OFF.).
Press one of FLEX 1-4 (Each FLEX 1-4 is assigned to station number 1- 4 on the
current LCD), then LED of pressed Flexible button is steady on. Dial new station
number and press the [HOLD/SAVE] button, or press other Flexible button to assign
station number to other station without saving (The LED of pressed Flexible button is
on.).
If you want to delete all station numbers, press the [SPEED] button and press
[HOLD/SAVE] button, then all station numbers are cleared.
If you want to change next 4 station numbers then press [▼] button. If you want to
change previous 4 station numbers, then press [▲] button.
000 001 002 003
100 400 102 103
Press the [HOLD/SAVE] button for saving database permanently. (Ex: Press FLEX 2,
dial 400 and press [HOLD/SAVE] button.)