Filter
Top Products
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
38
LAMP FUNCTION
You can illuminate the transceiver display by pressing
[LAMP]. Approximately 5 seconds after releasing
[LAMP], the light goes OFF if no other key is pressed.
Pressing any key other than [LAMP] while the display is
lit restarts the 5 second timer; pressing [LAMP] turns
OFF the light immediately.
To latch the light ON, press [F], [LAMP]. The light
remains ON until you press [F], [LAMP] again.
BEEP ON/OFF
The transceiver beeps each time you press a key on the
keypad. You can also switch this function OFF.
Access Menu No. 6 (BP) to switch the function ON
(default) or OFF.
SWITCHING AM/FM MODE
(U.S.A./ CANADA ONLY)
Your transceiver can also receive in AM mode.
Select the 118 MHz band, then access Menu No. 16
(F/A) to select FM or AM (default).
• A spade icon appears when you select AM mode.
TONE ALERT
Tone Alert provides an audible alarm to indicate when
signals are received on the frequency you are
monitoring. If used with CTCSS, the transceiver beeps
only when receiving the same CTCSS tones as you
selected.
Select the desired band, then press [F], [7] to switch
Tone Alert ON (or OFF).
• A bell icon appears when Tone Alert is ON.
• When receiving correct signals, an alarm sounds and the
bell icon starts blinking. Press the PTT switch to quit Tone
Alert.
• The display shows the number of hours and minutes
elapsed after signals were received. After 99 hours and
59 minutes pass, counting stops. When the next signal was
received, the time resets to 00.00 and counting continues.
Each time a new signal is received, the time resets to 00.00.
Note:
◆
While Tone Alert is ON, there is no speaker output when a signal is
received. To hear receive audio, press
[MONI]
.
◆
When Tone Alert is ON, APO does not turn the power OFF.
◆
When Tone Alert is ON, you can use only the following functions:
•
Lamp ON
•
Lamp Latch ON
•
Monitor
•
Squelch Level Select
2
1