Filter
Top Products
13
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
■ Selecting Offset Direction
Select whether the transmit frequency will be higher
(+) or lower (–) than the receive frequency.
1 Select the desired band.
2 Press [F], [REV].
• Each time you repeat this key operation, the offset
direction changes as shown below.
If the offset transmit frequency falls outside the
allowable transmit frequency range, transmitting is
inhibited until the transmit frequency is brought within
the band limits by one of the following methods:
• Move the receive frequency further inside the band.
• Change the offset direction.
Note:
While using an odd-split memory channel or transmitting, you
cannot change the offset direction.
■ Selecting Offset Frequency
Select how much the transmit frequency will be offset
from the receive frequency. The default offset
frequency on the VHF band is 600 kHz no matter
which market version; the default on the UHF band is
5 MHz (TH-G71A) or 1.6 MHz (TH-G71E).
1 Select the desired band.
2 Press [F], [BAND] to enter Menu mode.
3 Select Menu No. 8 (OFFSET).
4 Press [BAND], then select the appropriate offset
frequency.
• The selectable range is from 00.000 MHz to
29.950 MHz in steps of 50 kHz.
5 Press [BAND] again to complete the setting.
6 Press any key other than [BAND], [LAMP], and
[MONI] to exit Menu mode.
TH-G71E only:
If you have selected “
” for the offset direction, you
cannot change the default (–7.6 MHz).
Note:
After changing the offset frequency, the new offset frequency
will also be used by Automatic Repeater Offset.
Simplex
+
–
Simplex
+
–
: Pro
g
rams –7.6 MHz offset.
TH-G71A/E
(VHF)
TH-G71A
(UHF)
TH-G71E
(UHF)
1
2