Filter
Top Products
15
5 Press the PTT, MON, or CAL key to exit
Setting Mode.
To begin scanning:
1 Press and hold the ▲ key for 1 second.
•“ ” appears on the display.
2 When a signal is detected and the QT/ DQT
matches, the channel number appears on the
display and blinks.
3 When the signal is no longer present, the
transceiver waits for 5 seconds before
scanning continues.
• If a new signal appears before the 5 seconds
elapse, the transceiver will remain on the
channel until the new signal is no longer
present, at which time it will again wait for
5 seconds before continuing.
4 To end the scan at any time, press and hold
the ▲ key for 1 second.
• The transceiver returns to the channel you
were using before you started scanning.