Filter
Top Products
6
ENGLISH
GETTING STARTED
1 SWITCHING THE POWER ON/ OFF
To switch the transceiver power ON (or OFF), press and
hold the switch for 3 seconds.
• A tone sounds to confirm that the power has been switched
ON (or OFF).
2 SELECTING AN OPERATING MODE
1 Press and hold the MODE key to cycle through FRS, FM,
and FRS/FM Models.
• Each time you press and hold the MODE key for 0.5 seconds,
the operating mode cycles to the next mode.
• FRS, FM, or both icons appear, indicating the selected
operating mode.
2 Depending on the operating mode you have selected,
refer to the appropriate section:
• FRS Mode – page 7. FRS Mode allows you to send and
receive transmissions.
• FM Mode – page 10. FM Mode allows you to listen to FM
radio broadcasts.
• FRS/FM Mode – page 11. FRS/FM Mode allows you to
monitor only a single channel for sending and receiving
transmissions, while also listening to FM radio broadcasts.
3 ADJUSTING THE VOLUME
Press the ▲ or ▼ key to increase or decrease the volume
level.
• Press and hold the ▲ or ▼ key to continuously increase or
decrease the volume until you release the key, or until the
volume is at its maximum or minimum level.
• The volume level (1 ~ 8) appears for approximately
5 seconds before returning to the channel number/ station.
UBZ-GR14 E 1-20 01.4.12, 9:35 AM6