Grandstream Networks DP710 Cordless Telephone User Manual


 
Firmware version 1.0.0.23 DP715/DP710 User Manual Page 31 of 52
Using Star Code
1. Pick up the Handset and press then dial “*47
2. Enter the target IP address.
Note: NO dial tone will be played between step 1 and 2.
Examples of Direct IP Calls:
a) If the target IP address is 192.168.0.160, the dialing convention is
*47 or Voice Prompt with option 47, then 192*168*0*160.
followed by pressing the “#” key if it is configured as a send key or wait 4 seconds. In this case, the
default destination port 5060 is used if no port is specified.
b) If the target IP address/port is 192.168.1.20:5062, then the dialing convention would be:
*47 or Voice Prompt with option 47, then 192*168*0*160*5062 followed by pressing the “#” key if
it is configured as a send key or wait for 4 seconds.
Note: When completing direct IP call, the “Use Random Port” should set to “NO”.
CALL HOLD
Place a call on hold by pressing the “Recall” button on the Handset. Press the “Recall” button again to
release the previously held Caller and resume conversation.
CALL WAITING
Call waiting tone (3 short beeps) indicates an incoming call, if the call waiting feature is enabled. Toggle
between incoming call and current call by pressing the “Recall” button. First call is placed on hold. Press
the “Recall” button to toggle between two active calls.
CALL TRANSFER
Blind Transfer
This function is applicable using the Handset for VoIP calls only. Assume that parties A and B are in
conversation. PartyA wants to Blind TransferB to C:
1. A presses RECALL on the Handset to hear the dial tone.
2. A dials *87 then dials caller C’s number, and then # (or wait for 4 seconds)
3. A will hear the confirmation tone. Then, A can hang up.
Note: Enable Call Feature” must be set to “Yes” in web configuration page.
Threesituations can follow the transfer:
a. A quick confirmation tone (similar to call waiting tone) followed by a dial-tone: This indicates the
transfer is successful (transferee has received a 200 OK from transfer target). At this point, Caller
A can either hang up or make another call.