Filter
Top Products
BudgeTone-100 User Manual Grandstream Networks, Inc.
- 39 -
Automatic
Upgrade
Default is Yes. Choose Yes to enable automatic HTTP upgrade and
provisioning.
In “Check for upgrade every” field, enter the number of minutes to enable the
phone to check the HTTP server for firmware upgrade or configuration changes
in the defined period of time.
When set to No, the phone will only do HTTP upgrade and configuration check
once at boot up. Used by ITSP. End user should NOT touch these parameters.
Always Check for
New Firmware
The phone will check for new firmware once reboot and also when the
configured automatic upgrade time period comes
Check New
Firmware only
when F/W
pre/suffix
changes
The phone will check for new firmware once reboot and also when the
configured automatic upgrade time period comes, upon detected the pre/suffix
changes. Otherwise will quit the planed process.
Firmware Key
32 digits in Hexadecimal.
Once configured, the firmware will ONLY be changed if the key is matched.
This will lock the unit and firmware by ITSP.
Useful for ITSP to encrypt firmware. End user should keep it blank.
Authenticate
Conf File
Default No. Useful by ITSPs. End user should use default setting.
Once configured, only authenticated configuration file will be used.
Lock keypad
update
Default is No. The configuration update via keypad is disabled if set to Yes.
User can not change anything via key pad and only WebUI and configuration
file can be used to change setting if set to Yes.
Allow conf SIP
Account
in Basic Settings
Default NO.
If set to Yes, User ID, Authentication ID and Password can be configured in
basic settings.
This parameter is decided by related ITSP.
Override MTU
Size
Override the MTU size to meet some special network settings.
Default is “0”, means no override.
6.2.3 Saving the Configuration Changes
Once a change is made, the user should press the “Update” button in the Configuration Menu. The IP
phone will then display the following screen to confirm that the changes have been saved.