Filter
Top Products
5
Wall mounting holes
screw
INSTALLATION
Wall Mount Installation
Slide the handset hanger bar out and rotate it 180 degrees. Slide it back
into place. The hook will now point up. This ensures the handset will not fall
out of the cradle when it is mounted on the wall.
Plug the 8in short phone cord into the telephone jack on the AMPLI600, now
run the phone cord under the wall plate adapter and through the opening.
Insert the Wall Plate adapter. Hold it so that the raised mounting pins line
up with the phone’s keyholes on the AMPLI600. Once the holes are lined
up, push the wall plate adapter in towards the AMPLI600 and then slide the
plate upwards until it is securely placed on the phone.
Once the Wall Plate adapter is installed, plug the 8 inch short cord into the
jack on the wall.
Holding the phone slightly above the mounting screws on the wall jack,
push the phone against the mounting screws so they are hooked into upper
and lower key-hole slots on the back of the phone. Slowly slide the phone
down until it snaps into place.
Connect the handset curly cord to the handset and the other end to the
telephone.
Lift the handset, if there is a dial tone, the telephone is ready for use. If there
is no dial tone, check that everything is plugged in as described above.