Geemarc AMPLI600 Telephone User Manual


 
43
call is from an area not providing caller display, Unavailable number
will be displayed
It could be a call from a PBX. Caller display may not work properly if
the telephone is connected to a PBX
No response on LCD display
If you have experienced a power failure the batteries may become
weak. If the power is restored and the LCD display still does not re-
spond then replace the batteries with new ones.
No Strobe Ringer and/or bed shaker will not activate
Make sure the strobe and/or shaker switch is turned “ON
Make sure the Bed Shaker is plugged in correctly
No amplication
1. Check to see if the AMPLI amplify button is “ON”. You should see
the red light
There is Interference on the line
A filter may be required for homes with DSL line.
There is a red light that continues to ash.
You have un-reviewed Caller ID / Call Waiting information or missed a
call.
No Numbers in memory
No number stored in that memory button.
If your phone has been disconnected for a few hours the numbers
stored will be lost.
Emergency Connect button is not working
There may be a phone off the hook somewhere in your home.
Check the Auto On Hook Feature
The remote band’s battery is low or is not installed properly.
Check the antenna on base.
TROUBLESHOOTING