Filter
Top Products
4
Setting Up
Connect the curly cord and the handset.
Remove the screw of the battery compartment using the screwdriver pro-
vided and open the battery compartment.
Insert 4 good quality alkaline batteries (AAA size, 1.5V type, not supplied)
into the battery compartment located on the base of the telephone.
Note : Do not use rechargeable batteries. Do not put batteries into the
household rubbish, pay attention to battery regulations regarding battery
disposal.
Replace the battery cover.
Desk Installation
Connect the 6ft line cord to the jack located at rear of telephone then con-
nect the plug to the telephone wall socket.
Connect the power supply to the jack located on the back of the telephone
then plug into the wall socket. Please choose a socket near your telephone
socket to enable you to unplug the mains power quickly in case of a prob-
lem.
Lift the handset; if there is a dial tone, the telephone is ready for use. If there
is no dial tone, check that everything is plugged in as described above.
Note: Mains power is required to power the multifunction features of
the telephone. Fit 4 x AAA sized batteries in order to save and use
stored numbers in case of power failure. Without mains or battery
power, the telephone can still be used to answer calls or to manually
dial out calls but all stored numbers will be lost.
INSTALLATION