Filter
Top Products
6.
Troubleshooting Chart
PROBLEM
LED’s do not light.
j
Telephone does not
ope~ate during power
outages.
Telephone functions
with the handset, but
there is no response
to any button with the
phone on hook.
LED above intercom
button is flashing red
and green.
LED above Intercom
button is flashing red
and green and an erro
tone sounds when any
intercom station ad-
dress button is
pressed.
While programming th[
Intercom Station Ad-
dress the Intercom
LED flashes red, then
the phone beeps and
the Intercom LED
starts flashing red and
green again.
When making an inter-
com call the Intercom
●
LED turns green, then
an error tone is heard
and the LED turns off.
.
Telephone does not in-
dicate status of other
2-9450 telephones and
Intercom/Page is not
functioning.
SOLUTION
Is AC power supply plugged into an electrical
outlet and the telephone.
Is a good 9 volt battery installed? (A 9 volt
battery will allow use of the handset during
power outages.)
Is AC power supply plugged into an electrical
outlet and the back of the telephone.
k
Intercom Station needs to be programmed.
Press Intercom station address button.
Check that lines 1 and 2 are properly con-
nected to the telephone.
The Intercom Station Address selected is
already in use by another telephone. Select
another Intercom Station Address. (The inter-
com Station Address for a telephone can be
verified by pressing each station address but-
ton until a 3 beep tone is heard.)
Intercom Station being called is not assigned
.-
or has been disconnected. The intercom sta-
-,
tion address for a phone can be checked by
pressing all the station address buttons until
a 3 beep response is heard. )
Improper line connection. Perform System
Verification in the Installation Instructions.
(Step 5)
m