Filter
Top Products
D. Reverse the HANDSET HOOK by firmly sliding it
out of cradle, rotating it 180°, and sliding it back
into the cradle.
E. Remove the BACK COVER PLATE from the TELE-
PHONE BASE UN/T by pushing in the two tabs.
F. If the wall jack is Iabelled Line 1-2, connect the
short TELEPHONE L/NE CORD to the jack on
the telephone Iabelled LINE 1-2. If the wall jack
is Iabelled Line 3-4, connect the cord to the jack
on the telephone Iabelled L/NE 3-4.
G. Thread the SHORT TELEPHONE LINE CORD
through the square hole in the center of the
BACK COVER PLATE.
H. Connect a LONG TELEPHONE L/NE CORD to
the jack on the telephone Iabelled DC 9V.
1. Plug the AC POWER CORD into the jack on the
telephone Iabelled DC 9V.
Impotiant: Do not plug the AC PO WERCORD in-
to an electrical outlet at this point.
J. Thread the long TELEPHONE L/NE CORD and
the AC POWER CORD through the CHANNEL
on the back of the BACK COVER PLATE so that
the cords are taut at the top of the telephone.
(attach the BACK COVER PLATE to the BASE so
that the narrow end is at the top of the
telephone).
K.Hold the phone close to the wall jack and
connect the short TELEPHONE L/NE CORD to
the jack.
L. Hold the telephone against the wall jack face
plate so the studs on the face plate slide into the
keyholes on the BACK COVER PLATE. Slide the
telephone down firmly so that it is locked secure-
ly in place.
M.Connect either end of the COILED CORD to the
jack on the side of the TELEPHONE BASE UN/T.
Connect the other end to the jack in the HAND-
SET. Place the HANDSET on the HANDSET
HOOK.
N. Connect the long TELEPHONE LINE CORD to
the jack by the baseboard.