Filter
Top Products
●
O. Plug the AC POWER SUPPLY into the nearest
electrical outlet.
R After you plug in the AC POWER SUPPLY you
should see the /NTERCOM LED flash red and
green. Consult the WORKSHEET above to
see which Station Number you have assigned to
this telephone. Press that same number on the
MEMORY/lNTERCOM INDEX. The phone will
beep, and the LED will start flashing red as it
checks to see if this station address is already in
use. If this station address is not already in use,
the LED will turn off and the telephone will
automatically conduct a “line check”. During the
“line check” the line LED’s for each line con-
nected will turn green. After a few seconds all
LEDs will go off and you will here 3 beeps and
the telephone should be fully functional.
Note: If you hear an error tone, the intercom
number you pressed has already been assigned
to another station or the TELEPHONE LINE
CORDS are not properly connected. check the
LINE CORD connections. Check the station.
Check the extension number assignments on
your worksheet and repeat the procedure. (If you
need to change the address of a station, refer
to page 28 in the Use and Care Guide)
Q. If you desire, you may turn off the ringer for any
line or lines at any station. Press the STORE but-
ton and you should see a red LED for each LINE
button. The LED indicates the line is active and
will ring. To disable a ringer press these buttons
in this sequence to the right:
The LED should turn off, indicating a disabled
ringer. Repeat this sequence for each ringer you
wish to disable.
To turn a ringer back on: See page 23 of the
accompanying USE AND CARE GUIDE.
II
.:.
~
.. . .
,.
TO DISABLE
RINGER
‘“ k
2.
D
Omno
3“k
4.
w
LINf 1■
Note: For complete information on the programming and use of
your
GE Model 2-9450 telephone, consult the accompanying
USE AND CARE GUIDE.