Filter
Top Products
44
Unit locks up and no communication between the base and cordless handset
• Unplug the AC power supply from the wall outlet and the back of the
base. Remove the handset battery. Wait for 30 seconds and plug the
power supply back into the base and wall outlet. Reconnect the battery
and charge for 12 hours.
CALLER ID SOLUTIONS
No Display
• Is battery fully charged? Try replacing the battery.
• Make sure that the unit is connected to a non-switched electrical outlet.
Disconnect the AC power supply from the base and reconnect it.
Caller ID Error Message
• The unit displays this message if it detects anything other than valid
Caller ID information during the silent period after the first ring. This
message indicates the presence of noise on the line.
No Caller ID
• In order to receive Caller ID information, you must subscribe to the
standard name/number Caller ID service from your local telephone
company.
BATTERY SOLUTIONS
If you experience any of the following problems, even after fully
recharging the battery, you may need to replace the battery pack:
• Short talk time
• Poor sound quality
• Limited range