Filter
Top Products
12
tegraTesruoCdeepS*APC*APCT
1tegraTR°0.09tk0.01mn0.1nim4.01
2tegraTR°0.0tk0.0mn0.4 —
3tegraTR°0.081tk0.01mn7.1nim2.82
4tegraTR°5.612tk8.32mn9.0nim0.51
5tegraTR°5.372tk2.41mn0.6nim5.22
6tegraTR°0.081tk0.02mn0.0nim0.03
7tegraTR°6.42tkl6.51mn0.4nim6.34
atadlaitinI*
4. The simulation continues for five minutes
and then repeats. To quit the test se-
quence, turn the TRACK TEST off on the
PLOT MENU2.
14. Diagnostic Sequence
You can check the ATA Board for proper op-
eration as follows. The self test does not re-
quire operator intervention. It runs
automatically when the power is placed on
at regular intervals or on operator demand.
1. Press [MENU], [0], [0], [0], [0].
2. Press the [2] key twice to start the diag-
nosis sequence. The results of the test
appear as shown below.
FR-1500 M-3 Series Test
1. Program No. 03591521**
2. ROM Check OK
3. RAM Check OK
4. Antenna Rotation 24RPM
5. Tx Trigger Frequency 3000Hz
6. Video Level 000
7. Video Signal OK
8. Navigation I/O 1 OK
9. Navigation I/O 2 OK
10. NMEA Heading IN OK
11. LOG Pulse IN OK
ARP TEST
1. Program No. 18590411** 18590421**
2. ROM Check OK OK
3. RAM Check OK
4. Speed Log OK 0.0 KT
5. Course OK
6. Trigger OK
7. Video Signal OK
8. Bearing Pulse OK
9. Heading Pulse OK
10. Minimum 0003
11. Scan Time 0274
12. Manual Acq. 00
13. Auto Acq. 00
14. FE-Data 1 0000
15. FE-Data 2 0000
Press MENU key to escape.
Press ENTER to check CRT.
** Program No.
Figure 13 Diagnostics test results
(FR-1500 MARK-3 series)
3. If NG appears for any ATA-related item,
call for service.
4. To escape, press the [MENU] key.