Filter
Top Products
Connecting
Handset 1
1. Plug one end of the line cord into the jack at the back of the phone’s base,
and the other end into a modular phone jack.
2. Connect the AC adaptor as shown above, and plug into a standard
AC outlet.
3. The handset will display “Searching”, wait until “Handset 1” is displayed.
4. Press on the handset and confirm you hear the dial tone.
Handset 2
1. Connect the AC adaptor as shown below, and plug into a standard AC
outlet.
2. The handset will display “Searching”, wait until “Handset 2” is displayed.
3. Press on the handset and confirm you hear the dial tone.
AC adapter
modular phone jack
AC Outlet
line cord
insert here
AC adapter
Handset 2 cradle
AC Outlet
insert here
Handset 2 does not require a telephone jack
Rechargeable battery warning
● This equipment contains a rechargeable battery.
● Rechargeable batteries are known to the State of California to cause cancer.
● Do not short-circuit the battery.
● The rechargeable batteries contained in this equipment may explode if
disposed of in a fire.
● Do not charge the battery used in this equipment in any charger other
than the one designed to charge this battery as specified in the owner’s
manual. Using another charger may damage the battery or cause it to explode.
Telephone jack requirements
Important installation information
● Never install telephone wiring during a lightning storm.
● Never touch uninsulated telephone wires or terminals, unless the
telephone line has been disconnected at the network interface.
● Use caution when installing or modifying telephone lines.
● Never install telephone jacks in wet locations unless the jack is specifically
designed for wet locations.
● Temporarily disconnect any equipment connected to the phone, such as
faxes,other phones, or modems.