Filter
Top Products
Remote access
It is possible to access your messages and control the answering system
from anywhere using a standard telephone and the factory preset security
code (000), or you can select your own security code.
To remotely access your answering system:
1. Call the answering system.
2. After the outgoing message is played followed by a beep tone, slowly dial
the security code (000).
3. The answering system will confirm with two short beeps and will play-
back the remote voice guide.
4. Enter the correct code for the desired function (follow the chart below for
details regarding the remote voice commands).
To turn on the answering system from a remote location:
1. Call the answering system, the system will pick up after ten rings.
2. Dial the security code (000) after the message and beep tone.
3. Press “9”, a long beep confirmation will follow and the answering system
will be turned on.
Remote Code
1
2
3
4
5
6
7
8
9
0
*
Function
Rewind
Play / Pause
Fast Forward
OGM Playback
OGM Recording (Press 6 to stop)
Stop
Delete Current Message
Answering Off
Answering On
Delete All Old Messages
Skip Announcement
To change the “rings to answer” setting:
1. Press and HOLD the button until the system emits a
tone and the following voice prompt, “please set rings”.
2. Use the buttons to change the number of rings up or down.
3. If you select “TS” (toll saver) the answering system will
answer after 5 rings if there are no new messages, and
after 2 rings if there are new messages.
4. When you are finished, press the button to confirm
the setting.
Rings to answer
The answering system is factory preset to answer an incoming call after 6
rings, this however may be adjusted by following the instructions below:
To check the “rings to answer” setting:
• Press the button to check how many rings before the
answering system will respond to an incoming call