Doro 930R Cordless Telephone User Manual


 
English
www.doro.com 27
speak after the tone.” to end recording release the button.
The answering machine
About the answering machine
The answering machine has to be turned on in order to receive messages. On
incoming calls the answering machine will respond after the selected number of
rings (please refer to page 30).
When the answering machine answers the incoming call the caller will hear
your outgoing message (OGM) followed by a tone, at this point they can leave
a incoming message (ICM) up to 3 minutes in length. Should the caller exceed
this limit the call will be terminated. The memory can store up to 8 minutes of
incoming messages.
If the answer function is set to Answer only (ANN) the caller will not be able to
leave a message, as the call will be disconnected once the outgoing message has
been played.
Most functions can be performed from either base unit or handset.
The caller can also record their message in a speci c mailbox (please refer to
page 33), all voice mails are in English.
The display functions
The display on the base unit can show the following messages:
The display shows
Function
C
/
0-9
( ashes)
......................
Time and date requires programming, see
page 30
0-9
..........................................
The answering machine is ON, the number of
messages being displayed
9
( ashes)
................................
The answering machine is ON, with more than
nine messages recorded
-
/
0-9
(
 ashes
)
....................
The answering machine is off
A
(
 ashes
)
................................
Remote control access in progress (internal or
external)
E
( ashes)
................................
Temporary fault, disconnect the mains adapter
and telephone line for 1 minute
F
(
 ashes
)
................................
Memory full
P
(
 ashes
)
................................
Pause during playback
P
/
1
............................................
Normal answering function selected
P
/
2
...........................................
Answer only (ANN) function selected
r
...............................................
Recording in progress, please wait
t
,
2-9
....................................
Setting the number of rings before the machine
answers an incoming call
H
...............................................
Maximum volume