Filter
Top Products
2
7
SECTION 3 – PROGRAMMING
The DoorKing 1802, 1803, 1808 and 1810 Telephone Entry Systems can be programmed from the
keypad on the front of the entry system, or remotely from an off premise location using a touch tone
telephone. When programming from an off site location with a touch-tone telephone, the RING pin
must be installed on the circuit board (see Section 4). We recommend that you do not attempt
programming from an off site location until you become familiar with these programming instructions.
Programming from the Keypad
Follow the programming instructions as described in each section of this manual. The system will
prompt you with short (beep) tones when programming steps have been followed correctly, and with
a long tone (beeeeeep) when the programming step is ended. The 1802, 1803 and 1810 systems
have an LCD display that will prompt you for information that you will need to enter.
Programming from an Offsite Location
Follow these steps when programming the system from an offsite location. You must use a touch-
tone telephone and the RING pin must be installed to perform off site programming.
1. Call the telephone number that the entry system is installed on from a touch-tone
telephone. The entry system will answer with a one second tone.
2. Follow the programming instructions as described in each section of this manual. The
system will prompt you with short (beep) tones when programming steps have been
followed correctly.
3. When complete, hang up. (You cannot use 0 # to end remote programming sessions).
Programming Notes
When each programming step is performed correctly, a short tone (beep) will be heard. When the
programming session is ended, a long tone (beeeeeep) will be heard.
This symbol
in the programming steps indicates numbers that you will need to enter, one number
per symbol.
The amount of telephone numbers that can be programmed into the system is dependent on the
memory size ordered. Memory sizes available are 25 - 75 - 125 - 250 - 500 - 1000. The memory size
also determines the number of four-digit entry codes (memory size + 12) that can be programmed
into the system. Five-digit entry codes are limited to six.