Filter
Top Products
54
Auto Redial Times
Maximum number of auto redial attempts.
Auto Headset
Automatically answers call on headset.
Enable Intercom
If enabled, allows intercom calls.
Enable Intercom Tone
If enabled, plays intercom ring tone to alert to an intercom call.
P2P IP Prefix
Set Prefix for peer to peer IP call. For example: You wish to dial
192.168.1.119. If the P2P IP Prefix is defined as 192.168.1., it is
only necessary to dial #119. The default is “.”. If this box is left
blank, IP dialing is disabled.
Turn Off Power Light
Disables Power Light if selected.
Emergency Call
Number
The phone will dial the emergency call number even if the keyboard
is locked.
Enable Password Dial
When a number is entered beginning with the password prefix, the
following N numbers after the password prefix will be displayed as
*. N is the value entered in the Password Length field.
For example: If the password prefix is 3 and the Password Length is
2, then dialing the number 34567 will display 3**67 on the phone.
Password Dial Prefix
Prefix for password dialing as described above.
Password Dial Length
Length for password dialing as described above.
Ban Outgoing
If enabled, no outgoing calls can be made.
Enable Call Waiting
If enabled, notifies user of a second call during a call. Caller ID of
the new caller will be displayed. Press HOLD button to place
existing call on hold and answer new call. Press HOLD again to
return to first call.
Enable 3-way
Conference
If enabled, allows 3-way conference.
Accept Any Call
If enabled, the phone will accept a call even if the called number
does not belong to the phone.
Enable Call
Completion
This is similar to Auto Redial except that the phone detects the state
of the called number before making a new call attempt.
Enable Pre-Dial
If this feature is enabled, digits dialed on-hook will be transmitted
when the phone goes off-hook.
Enable Silent Mode
If enabled, the phone will not ring to indicate a new call. Instead,
the light below the key pad will blink to indicate a new call.
Hide DTMF
This feature sets how DTMF digits are displayed after a call is in
progress. For example, dialing a PIN code to access banking
information. There are 4 choices.
3. Disabled – All the digits will be shown on the LCD.
4. All – None of the digits will be shown on the LCD. The “*”
will be shown.
5. Delay – The last digit entered will be shown for a short time and
then replaced by “*.”
6. Last Show – The last digit entered will be shown. Previous
digits are replaced by “*.”