Filter
Top Products
To Use The Intercom/Pager
As A Handset Locator
1. To locate a misplaced handset around
the home, press and release the
INTERCOM/PAGE button on the base.
2. The handset will sound a series of
three beeps for 30 seconds, giving you
time to locate it. Once found, press and
release the INTCM button on the handset
twice to eliminate the signal.
3. If you have not located the handset in
30 seconds, repeat steps above.
If you want to record your conversation,
you must ask the person to whom you
are speaking for their permission. Press
and immediately release the MEMO/2-
WAY record button. The LED display will
read 2–. To stop recording, press STOP
button or hang up.
To Use The Intercom
1. If you are at the handset and wish to
speak with someone at the base, press
and release INTCM which will sound
three beeps and light the red indicator
next to the INTERCOM/PAGE button on
the base. The person may then respond
just by speaking into the base.
2. If you are at the base and wish to page
someone at the handset, press and
release INTERCOM/PAGE, which will
sound a series of three beeps and light
the INTCM button on the handset. The
person may then respond by pressing
INTERCOM and speaking into the
handset. The LED display will read In
3. To end the conversation, simply press
the INTCM button on the handset again.
You cannot disconnect the INTCM from
the base.
4. If you receive a call during an intercom
conversation, you will hear a low volume
ringing in the handset. Press TALK, which
will disconnect the intercom and connect
you with the incoming call.
5. If you wish to page someone at the
base while you are talking on the phone,
press HOLD then INTCM. TALK button
will flash to remind you you have a call on
hold. Press TALK to disconnect Intercom
and resume your phone call.
6. If someone tries to reach you on the
Intercom while you are talking on the
handset, you will hear three rings. Press
HOLD, then INTCM on the handset. (The
base will beep and Intercom will activate.
LED will flash when there is a call on
hold). Your caller will then be put on hold
while you answer the INTCM. The TALK
button will flash to remind you that you
have a call on hold. Press TALK again to
disconnect the INTCM and reconnect
with your telephone call.
Cobra
®
To Use The Intercom As
A Monitor
Monitor the room in which the base is
located from another location using the
Intercom feature.
1. Press INTCM button on handset. This
engages the Intercom microphone in
the base, allowing you to listen to the
base location area.
2. Listen through the handset for as long
as you like.
3. Disconnect by pressing INTCM again.
4. If you receive an incoming call while
you are using the monitor, you will
hear a ringing in the handset.
5. Press TALK to connect the call. The
Intercom is automatically
disconnected.
1
1-773-889-3087
NEED HELP?
Cobra
®
3
4
USING THE 2-WAY RECORDING
FEATURE
1
2
1
INTCOM
BUTTON
1
INTCOM
BUTTON
1
INTCM
BUTTON
2
INTERCOM/
PAGE
BUTTON
3
TALK
BUTTON
REPEAT SKIP
AN8630-25
Cobra
®
1
2
INTCM
BUTTON
1
INTCM
BUTTON
1
INTCM
BUTTON
INTERCOM/
PAGE
BUTTON
3
TALK
BUTTON
3
TALK
BUTTON
4
HOLD
BUTTON
1
INTCM
BUTTON
3
TALK
BUTTON
4
HOLD
BUTTON