Filter
Top Products
RAV-Ware — Configuring System Settings
31
RAV-Ware — Introduction
30
Network Find
Network Find allows you to connect to any RAV system on your network using its IP
address or a unique network name. Use Network Find to access RAV units not listed in the
Connections pane, but which reside on the same network.
To open the Network Find
• Click the
Network Find
icon on the toolbar.
To connect to a system on the network
1. Enter the
IP address
or
name
of the RAV system to
which you want to connect.
2. Click
OK
.
3. You will see a password prompt window. Enter the
User name
and
Password
of the networked system.
The default user name is
ClearOne
and the default
password is
RAV.
4. Click
OK
.The system icon will appear in the
Connection list and the Configuration screen will
open.
Note
: Once you have connected to a RAV unit using
Network Find, a shortcut connection icon for that unit
will display as long as RAV can find the unit on the
network. If RAV cannot find the unit, the shortcut icon
will be removed.
Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760
System settings include Communication, Regional and Telephone settings.
Communication Settings
The Communication Settings window allows you to adjust the connectivity settings of
external devices that communicate with the RAV, including the network, serial or USB
connections.You can connect a PTZ camera to the Camera port and use the Voice Tracking
feature.You can also change the RF frequency to match the frequency of your controller or
if you are experiencing interference on the current channel.
To open Communication Settings
• Click the
Communications
icon in the Configuration screen.
Note
: When RAV is connected to a DHCP network, the network, IP,
gateway and subnetwork addresses are automatically assigned. Unless you
want to specify a static IP address, there is no need to configure network
settings.
To create a static IP address
Note: Contact the network administrator for
network settings.
1. In the Networking tab, create a unique network
name and enter it in the
Device Name
field.
(Default is ClearOne-XX where XX is the last two
digits of the MAC address.)
2. C
lear the Use DHCP option and enter the IP,
Subnet and Gateway addresses.
3. Select
Use DNS
if you have a Domain Name
Server and want name resolution (to use a net-
work name) for your static IP address.
4. In the IP Filters section,enter specific IP
addresses that will be allowed to access the RAV
system.
You can specify a range of IP addresses by using
zeros. For example, entering 192.168.105.0 will
allow any IP addresses in the 192.168.105.1 to
192.168.105.254 range to access the RAV sys-
tem.
5. Click
OK
.
6. Click
Yes
to save your settings.
Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760
Figure 3.8. Network settings
Configuring System Settings
Figure 3.6. Network Find
Figure 3.7. User name/Password
Figure 3.9. Confirm changes