Filter
Top Products
Appendix
Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760
15
Maintenance
14
Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760
Appendix
DIMENSIONS (W x D x H)
Phone section: 10.5" x 10.5" x 3"
(26.7 cm x 26.7 cm x 7.6 cm)
Base unit: 4.25" x 5.5" x 2.5"
(10.8 cm x 14 cm x 6.4 cm)
WEIGHT
Phone section: 2.7 lb (1.2 kg)
Base unit: .6 lb (0.27 kg)
Shipping: 10 lb (4.5 kg)
ENVIRONMENTAL
Operating Temperature: 0–50° C
(32–122° F)
Storage temperature: 5–70° C
(41–158° F)
Operating Humidity: 15 to 80%
Storage humidity: 10 to 90%
POWER
Pod section:
Custom battery pack with nickel
metal hydride batteries, 7.2 V
2200 mAh
12 hours continuous talk time
(typical)
Base unit:
Auto-adjusting power module;
100–240VAC; 50/60 Hz
TELEPHONE CONNECTION
Analog PBX or PSTN line
RJ-11C/CA11A, –12dBm nominal
KEYPAD
Alphanumeric standard keypad
LOUDSPEAKER VOLUME
90 dBspl A weighted @ 1 ft
Bandwidth: 200Hz - 3.3kHz
RADIO FREQUENCY
2.4 GHz WDCT
1.8 GHz DECT
(4) 32kbps full duplex
RECORD OUTPUT
Connector: 2.5 mm mono audio
jack
Impedance: <1000 ohms
Bandwidth: 200Hz–3.3kHz
Dynamic Range: 60dB
THD <.01%
ECHO CANCELLATION
Tail Time: 60 mS x 3
NOISE CANCELLATION
Dynamic noise cancellation
CERTIFICATIONS
FCC Part 15/ICES-003 Class A
FCC Part 15 Subpart C/RSS-210
FCC Part 68/IC CS-03
CE
UL, C-UL Certified
WARRANTY
2 Years
MODELS
Max Wireless WDCT*
Max Wireless DECT*
*Call your sales representative for part numbers.
Specifications
If you hear It could be that
Beeping sound
before dialing
No dial tone
Static or noise
Calls can come
in, but you can't
dial out.
Try this
Pod section is out of
range
Base unit is not powered.
Move pod section closer to the
base unit.
Make sure base unit is plugged
into a power outlet and the
Power LED is lit.
Base unit is not
connected to telephone
jack.
You are not using an
analog phone line.
Connect the base unit to the
telephone jack using the
supplied telephone cable.
Check that you are using an
analog phone line. Consult your
IT department for help.
You have a bad
telephone connection.
You have a bad
telephone line.
The other party's room
is too noisy.
Place the call again to see if
another line provides a better
connection.
Plug a working phone into the
phone jack. If the line is still
noisy, call your telephone
company.
Ask the other party to turn off
noisy equipment.
The dialing mode (tone
or pulse) is set
incorrectly for your
service.
See page 10 for instructions
on changing the dialing mode.
Poor audio
Building construction is
limiting phone range.
The equipment on the
far end is of lesser quality.
Move base unit closer to the phone.
The equipment should be upgraded.
Participants can try sitting closer
to equipment and eliminate
background noises.