Filter
Top Products
Appendix
Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760
17
Appendix
16
Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760
Notice
A plug and jack used to connect this equipment to the premises wiring and telephone network
must comply with the applicable FCC Part 68 Rules and Requirements adopted by the ACTA.
A compliant telephone cord and modular plug is provided with this product. It is designed to be
connected to a compatible modular jack that is also compliant. See installation instructions for
details.
If you experience problems with this equipment, contact ClearOne Communications, 1825
Research Way,Salt Lake City,Utah 84119, or by phone at (801) 975-7200 for repair and
warranty information. If the trouble is causing harm to the telephone network, the telephone
company may request you remove the equipment from the network until the problem is
resolved.
No user serviceable parts are contained in this product. If damage or malfunction occurs, con-
tact ClearOne Communications for instructions on its repair or return.
This equipment cannot be used on telephone company provided coin service. Connection to
Party Line Service is subject to state tariffs.
IC Compliance
IC: 1970A-910158
Ringer Equivalence Number (REN):0.1B(ac)
Notice
The term "IC" before the certification/registration number signifies that Industry of Canada
technical specifications were met.
This certification means that the equipment meets certain telecommunications network protec-
tive operational and safety requirements.The Department does not guarantee the equipment will
operate to the user's satisfaction.
The REN is used to determine the quantity of devices, which may be connected to the telephone
line. Excessive RENs on the telephone line may result in the devices not ringing in response to
an incoming call.In most, but not all areas, the sum of the RENs should not exceed five (5.0).
To be certain of the number of devices that may be connected to the line, as determined by the
total RENs, contact the telephone company to obtain the maximum RENs for the calling area.
Before installing this equipment, users should ensure that it is permissible to be connected to
the facilities of the local telecommunications company.The equipment must also be installed
using an acceptable method of connection. In some cases, the companies inside wiring associat-
ed with a single line individual service may be extended by means of a certified connector
assembly (telephone extension cord).The customer should be aware that compliance with the
above conditions may not prevent degradation of service in some situations.
Repairs to certified equipment should be made by an authorized Canadian maintenance facility
designated by ClearOne Communications. Any repairs or alterations made by the user to this
equipment, or equipment malfunctions, may give the telecommunications company cause to
request the user to disconnect the equipment.
Users should ensure for their own protection that the electrical ground connections of the power
utility, telephone lines and internal metallic water pipe system, if present, are connected togeth-
er.This precaution may be particularly important in rural areas.
European Compliance
This equipment has been approved in accordance with Council Directive 1999/5/EC "Radio
Equipment and Telecommunications Equipment" (see insert enclosed with phone).
Compliance
FCC Part 15/ICES-003 Compliance
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC rules and Industry Canada ICES-003.These limits are
designed to provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment.This equipment generates,uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction manual,may
cause harmful interference to radio communications. Operation of this equipment in a residen-
tial area is likely to cause harmful interference, in which case the user will be required to cor-
rect the interference at his/her own expense.
Operation is subject to the following two conditions: (1) This device may not cause interference,
and (2) This device must accept any interference including interference that may cause unde-
sired operation of the device.
Changes or modifications not expressly approved by ClearOne Communications could void the
user's authority to operate the equipment.
FCC Part 15 Subpart C/RSS-210
Noise
Electrical pulse noise is present in most businesses at one time or another. This is most intense
during electrical storms. Certain kinds of electrical equipment, such as light dimmers, fluores-
cent bulbs, motors, fans, etc., also generate pulse noise. Because radio frequencies are suscepti-
ble to this, you may on occasion hear pulse noise through the speaker, this is usually only a
minor annoyance and should not be interpreted as a defect of the unit.
RF Radiation Exposure
This equipment complies with FCC RF Radiation Exposure limits set forth for the uncontrolled
environment. This equipment should be installed and operated with a minimum distance of 20
centimeters between radiator and your body.
FCC Part 68/IC CS-03 Compliance
US:FBIWI01B910158001 Ringer Equivalence Number (REN): 0.1B(ac)
This equipment complies with Part 68 of FCC Rules and Technical Requirements for Telephone
Terminal Equipment published by ACTA. The marking on the base unit of this equipment con-
tains, among other information, the US number and ringer Equivalence Number (REN) for this
equipment. If requested, this information must be provided to your telephone company.
The REN is used to determine the quantity of devices, which may be connected to the telephone
line. Excessive RENs on the telephone line may result in the devices not ringing in response to
an incoming call.In most, but not all areas, the sum of the RENs should not exceed five (5.0).
To be certain of the number of devices that may be connected to the line, as determined by the
total RENs, contact the telephone company to obtain the maximum RENs for the calling area.
If this equipment causes harm to the telephone network,the telephone company will notify you
in advance that temporary discontinuance of service may be required. If advance notice is not
practical, the telephone company will notify the customer as soon as possible.Also, you will be
advised of your right to file a complaint with the FCC if you believe it is necessary.
The telephone company may make changes in its facilities, equipment, operations,or procedures
that could affect the operation of the equipment.If this happens, the telephone company will
provide advance notice for you to make the necessary modifications in order to maintain unin-
terrupted service.