ClearOne comm 900 Conference Phone User Manual


 
RAV-Ware — Configuring System Settings
RAV-Ware — Customizing RAV Components
35
Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760
34
Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760
Your RAV system is pre-configured for optimal audio quality right out of the box. However,
you can customize the audio and adjust the volume to match user preferences.You can also
change the mix of audio being sent to the far-end conference site and recording devices.
Microphones
You can adjust microphone volume and enable or disable ALC (automatic level control) in
the Microphone Settings window. Automatic Level Control automatically adjusts microphone
levels to ensure participants’ voices are transmitted at consistent levels regardless of whether
people are speaking loudly or softly.
To access Microphone Settings
Click the Mic Pod icon on the Configuration screen.
To enable ALC
Click the ALC button.The indicator will turn green when
ALC is enabled and the audio level sliders will be
disabled.
To adjust audio level (volume)
Using the slider, adjust the volume.The meter will display
output levels.
To disable Acoustic Echo Cancellation (AEC)
1. Click the
Advanced
button.
2. Click
AEC
to disable Acoustic Echo Cancellation.
Note: AEC prevents echo from reaching the far-end site.
AEC should be kept enabled for normal operation.
To disable Noise Cancellation (NC)
1. Click
Advanced
.
2. Click
NC
to disable noise cancellation.
Note:Noise Cancellation prevents ambient or background
noise from being sent to the far-end. ClearOne
recommends keeping NC enabled.
Customizing RAV Components
Figure 3.17. Microphone settings
To change telephone preferences
1. In the Preferences tab, set the system to
Auto-Answer
after
2 Rings
or
4 Rings
or
select
Disabled
if you want to manually
answer calls.
2. Select
Auto-Disconnect
if you would like
RAV to disconnect when it detects loop-
drop or call progress tones.
3. Select from three available ringer melodies.
Click
Ringer Test
to hear selected melody.
Note
:This option is only available when you are connected to a RAV unit.
4. Select
Audible Connect
if you would like one tone to sound when the RAV is taken off hook
and two tones to sound when the RAV is on hook.
5. Adjust ringer volume using the
Ringer
Level slider.
6. Enter the
Local Number
for the RAV
system.The local number displays on the third line of the RF Controller LCD.
To select telephone configuration
1. In the Configuration tab, select the
Country
where the phone is being used.
2. Select the flash duration from the Flash
Setting list.This setting is dependent on
the requirements of your PBX or
telephone provider.
Warning
: The country code must be set
correctly in RAV-Ware and the RF
Controller to ensure that the unit operates
properly and that it complies with the
country’s telco requirements. Changing this
code to a country other than the intended
country of operation might cause the RAV
to be non-compliant.
To adjust telephone volume
1. Select
Receive ALC
. Clearone recommends
keeping Receive ALC (automatic level
control) selected.This feature adjusts the
far-end audio to keep it at a constant level.
2. Use the sliders to adjust the level of the
telco transmit and telco receive.
Note
: If you select ALC, the Telco Receive
slider is disabled.
Figure 3.14.Telephone preferences
Figure 3.15.Telephone configuration
Figure 3.16.Telephone level
Figure 3.18.Advanced settings