Filter
Top Products
35
3. Using the or arrow buttons, scroll through the numbers and select the
number you wish to delete.
4. Press the C button.
5. The Screen will display “DEL?”
6. Press again the C button to confirm.
7. Press the OK button to exit.
Auto On Hook
Should you leave the CSC50-ER or another telephone off the hook, when the Auto On
Hook feature is ON, your ClearSounds CSC50-ER will automatically hang-up the line after
5 - 8 minutes and your CSC50-ER Phone will ring as you selected so you never miss a
call (See page #20).
Troubleshooting Guide
No dial tone
1. Check that all phone cord connections (including the curly cord) and AC Adapter are
securely plugged into the telephone & wall jack.
2. Check that the phone is in the correct dialing mode, Touch-Tone / Pulse Setting.
3. Plug another phone into the jack to make sure your phone service is functioning
properly.
Call will not dial or dials very slowly
1. Check that the phone is in the correct dialing mode, Touch-Tone / Pulse Setting (See
page #12)
.
No audible ringer
1. Make sure the ringer is not set to the “OFF” position (See diagram #11).
2. Check the volume level of the ringer.
3. You may have too many extensions on your line. Try unplugging a few devices.
Having too many telephones /accessories can also create problems such as low
ringer volume or impaired quality during calls.
No Strobe Ringer and/or bed shaker will not activate
1. Make sure the strobe and/or shaker switch is turned “ON”(See diagram #15).
2. Make sure the Bed Shaker is plugged in all the way.
3. Make sure the Bed Shaker is plugged into the correct jack (See diagram #14).
No amplification
1. Check to see if the AMPLI amplify button is “ON” (See diagram #23). The red light
should be lit.
2. Check the AC Power Adapter and make sure it is plugged into the wall and into the
appropriate jack on the phone.