Filter
Top Products
10
Installation Steps
Installation of your ClearSounds™ CSC50-ER Emergency Connect Phone is easy. There
are some basic steps you need to take when you set-up your CSC50-ER Emergency
Connect Phone for the first time.
1. Check parts list.
2. Install (4) AAA Alkaline batteries (not included). Batteries are necessary in case of
network power failure to save stored numbers in memory and are required for the
“Phone Book” use.
3. Choose desktop or wall mount.
4. Set the dialing mode.
5. Set ringer and auxiliary alert.
6. Program your memory dial buttons.
COMPONENTS
Check to be sure you have all items that come with your telephone. You should have a
REMOTE BAND, TELEPHONE BASE UNIT, TELEPHONE HANDSET, 6 ft LONG TELE-
PHONE LINE CORD, 8 inch SHORT TELEPHONE LINE CORD, HANDSET COIL CORD,
WALL PLATE ADAPTER, SCREWDRIVER, AC ADAPTER, AND OWNERS MANUAL
INSTALLING THE OPTIONAL BATTERIES
The batteries are necessary in case of network power failure to save stored numbers in
memory and are required for the “Phone Book” use.
1. Open the battery compartment door located on the bottom of your phone by un-
screwing the battery compartment door and removing it from the bottom of your
phone (screwdriver provided).
2. Insert correctly 4 AAA alkaline batteries (purchased separately) in the battery com-
partment (See diagram #6). Be sure to observe battery polarity as imprinted on the
base of the compartment.
3. Replace the battery compartment door and screw back in place.
4. The batteries will last approximately 1 year before needing replacement.
NOTE: Always unplug the line cord before installing new batteries.
DIAGRAM #6- Installing the batteries