Filter
Top Products
11
PHONE MOUNTING INSTALLATIONS
Choose a location for the CSC50-ER Emergency Connect Telephone that is as central
as possible in the house, while providing access to a modular jack and an AC outlet. The
telephone may be placed on a shelf or table, or may be fixed to a wall using the mounting
bracket.
Plug the AC Adapter into the AC power back on the back of your phone, then into an
electrical outlet or surge protector, if you are using one. NOTE: The adapter is required
for the telephone to work correctly. If the adapter is accidentally unplugged (or in case
of power failure) and if the batteries are dead or not installed, minimal restricted phone
features only will work on the phone (make a call or answer incoming call).
IMPORTANT: Please remove the clear plastic Caller ID tab. This film tab is only for display
and to protect your Caller ID display during shipping.
Desk / Table Use
1. Connect one end of the 6ft telephone cord to the line jack on the back of your
CSC50-ER Phone and connect the other end to a modular phone jack (RJ11C).
2. Connect the handset coil cord (curly cord) to the handset and to the telephone (See
diagram #7)
.
3. Lift the handset and listen for a dial tone. If you hear a dial tone, your phone is ready
to use. If there is no dial tone, check all your cords to make sure they are plugged in
securely.
Wall Mount Use
1. Slide the handset hanger tab out and reverse its position (rotate it 180 degrees).
Slide it back into place so that the hook points up (See diagram #8). This will keep
the handset from falling out of the cradle when it is mounted on the wall.
2. Plug the 8in short phone cord into the telephone jack on the CSC50-ER, run phone
cord underneath wall plate adapter and through the opening.
3. Insert the Wall Plate adapter. Hold the wall plate adapter so that the raised mounting
pins line up with the phone’s keyholes on the CSC50-ER. Once the holes are lined
up, push the wall plate adapter in towards the CSC50-ER and then slide the plate
upwards until it is securely seated on the phone. (See diagram #9)
4. With the Wall Plate adapter installed, plug the 8in short phone cord into the jack on
the wall.
DIAGRAM #7 – Desk Installation