Filter
Top Products
6 7
E
N
G
L
I
S
H
Connect your telephone as shown on the enclosed Quick Start guide.
Your telephone should arrive pre-assembled. To install it:
1. Remove base from package.
2. Hold one end of your XLC3.4’s long phone line cord tightly. The
correct end to hold should already be plugged into your phone’s jack.
Simultaneously pull the other end of the phone cord away from the phone,
unraveling it and allowing you to plug that end of the cord into a wall
telephone outlet.
3. Plug the loose end of the phone cord into the wall telephone outlet.
4. Hold one end of your phone’s white power adapter cord tightly. The
correct end to hold should already be plugged into the back of your
telephone base unit. Simultaneously pull the other end of the adapter cord
away from the phone, unraveling it and allowing you to plug that end of the
cord into a wall electrical outlet.
5. Plug white power adapter cord on left rear of the base into a wall
electrical outlet.
6. Remove handset from package.
7. Pull the handset’s battery tab located on the bottom of the device in the
direction of the arrow.
8. Place the handset in the base charger. The batteries in the handset must
be fully charged for 10 hours before using the telephone for the first time.
9. Lift handset and press TALK to test. If you hear a dial tone, your
telephone is ready for use. If not, check all connections again.
INSTALLATION
XLC3.4
INSTALLATION
XLC3.4
apide Guía de Inicio Rápido