Filter
Top Products
28 29
E
N
G
L
I
S
H
HANDSET REGISTRATION
XLC3.4
Register
VoiceAsst
AutoTalk
Register
Deregister
Register
HoldBase
For5Secs
FINDKey
ThenPress
MENUKey
Registering...
Registration
Successful
HANDSET1
Deregistered
Handset
Needs
Registration
Register
Deregister
Register
TROUBLESHOOTING
XLC3.4
The unit will not operate / no dial tone:
• Verify the AC adapter is securely plugged into the AC outlet, the
base and the telephone.
• Verify the telephone line cord is securely plugged into the wall jack
and the telephone.
• Make sure the handset battery is fully charged.
• Make sure the battery has been placed in the battery compartment
correctly. (The circular metal contacts on battery need to touch
the metal springs inside battery compartment.)
• Verify the telephone is in the correct dialing mode: Tone (touch)
or Pulse (rotary).
• Make sure you are in the usable range of the base station.
The phone does not ring when you receive a call:
• Make sure the RINGER switch on both handset and base is
set to ON.
• Verify the AC adapter is securely plugged into the AC outlet,
the base and the telephone.
• Verify the telephone line cord is securely plugged into the wall
jack and the telephone.
• Make sure you are within the usable range of the base station.
• You may have too many extensions on your line. Try unplugging
a few devices.
Noise, interference or other calls heard while using the
handset:
• Make sure you are within the usable range of the base station.
• Make sure the handset battery is fully charged.
• Try relocating the base unit to another location.
• Make sure the AC adapter is not plugged into the wall outlet
with other appliances.
REGISTERING THE XLC3.4
In order to use the XLC3.4 (or XLC3.1) handset, you must
register it to the XLC3.4 base.
Pull the handset’s battery tab located on the bottom of
the device, and then press MENU to start registering or
deregistering your handset from your system.
TO REGISTER AN UNREGISTERED HANDSET
1. Press MENU to enter registration mode. You will see
displayed on the screen, “Handset Needs Registration.”
2. Press and hold the FIND key on the XLC3.4 base for five
seconds, until the base visual ringer starts flashing. Release
FIND key on the XLC3.4 base.
3. Press MENU key on the handset.
4. The screen shows “Registering... ”, then “Registration
Successful” (accompanied by five quick beeps).
5. Your handset is now registered to your XLC3.4 system.
Your screen will display “Handset X,” (where “X” is the
number of the actual handset registered, such as the second
or fourth handset, etc.).
You can extend the number of handsets by using additional
XLC3.1 handsets (sold separately).
TO REGISTER YOUR HANDSET AGAIN (or to
register to a different XLC3.4 system)
1. In standby mode, press MENU.
2. Press DOWN arrow five times to advance the row
reading “Phone Setup” to the top of the screen.
3. Press MENU to enter the setup section. The screen
displays “Register” on the screen’s top row now.
4. Press MENU to enter the Registration section.
5. Press MENU again to select “Register.”
6. Follow the Registration steps listed above.
TO DEREGISTER THE HANDSET
1. See the six steps listed above, then press MENU to select
“Deregister.”
2. Your handset will deregister from your base as
soon as you press MENU. The screen will show “Handset
X Deregistered”(again, where “X” is the number of the
handset registered), then “Handset Needs Registration.”