Filter
Top Products
8
Package Contents
• Ensemble amplied telephone
• Wireless Access Point (WAP) (power supply and Ethernet cable connected to your
unit)
• Quick installation guide
• User guide
Installation
Your product comes completely assembled. Please note: to enable
the captioning feature, you need access to high-speed Internet in
your home.
Install WAP rst – follow directions below before installing your Ensemble
1. Pull the ends of the Ethernet cable to untangle the cable.
2. Locate the LAN ports on your router; you will need an available LAN port, typi-
cally located on the back of the router. If you have high-speed wireless Internet,
you may have a modem that is separate from your wireless router.
3. Plug the free end of the Ethernet cable from the WAP (provided with your En-
semble) into the available LAN port on your router (identied at step 2, above)
4. Pull the ends of the power supply cord to untangle the cable.
5. Plug the power supply for the WAP in an electrical outlet, located close to your
router.
6. Wait for 5 minutes to allow the WAP to completely nish conguring itself –
which ensures it is ready to successfully connect with your Ensemble.
7. The WAP is completely congured when two blue lights (“Power” and “Wire-
less” and one amber light (“LAN” or “WAN”) appear.
Ensemble installation – install after completing the previous WAP installation
1. Pull the ends of the phone cord to untangle the cord.
2. Plug the loose end of the phone cord in the phone line wall outlet.
3. Pull the ends of the power supply to untangle the cable.
4. Plug the power supply into the wall electrical outlet.
5. Wait for the Ensemble to nish its startup routine; this may take a few minutes; at
the end of the process, the message “READY” is briey displayed.
6. A few seconds (up to a couple of minutes) later you will notice the Wi-Fi symbol
on the upper status bar on the screen – the connection to the WAP is now com-
plete (if you chose to use the WAP provided with your Ensemble for the setup –
see alternative solution below).
7. Your Ensemble is ready to be used when the numeric keypad appears on the
screen, and the Wi-Fi symbol is displayed on the upper line.
NOTE: IMPORTANT! Use only the power adapter supplied with your
Ensemble. Using a different power supply may damage your Ensem-
ble and voids the warranty.
NOTES:
• The WAP is provided with your Ensemble for your convenience – this congura-
tion allows you to use the unit without using the SSID and password from your
home network.
• You may experience shorter Wi-Fi range when using the WAP (compared to
other Wi-Fi devices in your home); this can be addressed by moving your Ensem-
ble closer to the WAP.
• Alternatively, you can choose to connect your Ensemble directly to your home
network (and not install the WAP). The unit can connect to routers with WPA/
WPA2 personal security settings. Please refer to the “Connection” section in this
user manual for further requirements/instructions.
• Ensemble does NOT support WEP personal security settings.
INSTALLING YOUR ENSEMBLE