Filter
Top Products
54
USING YOUR CORDLESS HANDSET
REGISTER/DEREGISTER HANDSETS
Your telephone can support up to ve cordless handsets. The handset needs to register
with the telephone base before use. You must register each handset separately.
The handsets provided within your product box are already registered as
HANDSET 1 and so forth. Additional handsets are assigned numbers in the order
they are registered (HANDSET 2 to HANDSET 5).
When rst purchased, all expansion handsets alternately display:
1. Press <PAGE/FLASH> on base 4 sec
– and –
2. Then press # on handset.
The new handset should be charged without interruption for at least 30 minutes before
registering to the telephone base.
Register a handset
1. In idle mode, press <MENU/SELECT>, then <UP/DOWN> to
select Registration.
2. Press <MENU/SELECT> and screen will alternately show
3. Press <PAGE/FLASH> on base 4 sec
– and –
4. Then press # on handset
5. Press and hold <PAGE/FLASH> on the telephone base for about four seconds,
until you hear a beep.
6. Press # (pound key) on the handset. The screen shows “Registering...
Please wait”.
Note: NO LED indication and Alert Tone to indicate the base is under registration mode.
When the handset is registered successfully, “HANDSET” registered and then
“HANDSET X” appears on the screen, with X being the handset number (1-5).
If the registration is not successful, the handset screen shows “Registration failed”.
Please start again from step 1 above.
Note: You cannot register a handset if any other system handset is in use. To register an
expansion handset, follow from the step 3 as above.