Filter
Top Products
24
3. Press <OK/MENU> to conrm the setting; display shows Saved, you will hear a
beep; display goes back to the previous menu.
RINGER SETUP
Change Ringer Volume and Tone
1. Press <OK/MENU> and <UP/DOWN> to select Ringers.
2. Press <OK/MENU>; display shows Ringer Volume.
3. Press <UP/DOWN> to select the ringer volume that best suits your needs; phone
rings to indicate current level.
Note: If ringer volume is OFF, display shows the ringer off icon.
1. Press <OK/MENU> to save; display shows Saved, then returns to previous screen.
2. Press <UP/DOWN> button to go to Ringer Tone; press <OK/MENU> to
change the ringer tone.
3. Press <UP/DOWN> button to scroll through the ringer tone list (from Tone 1 to
Tone 10).
4. Press <OK/MENU> to conrm the setting; display shows Saved, you will hear a
beep; display goes back to the previous screen; press <CLEAR/MUTE> to return
to previous menu.
Note: The respective ringer melody will be played during your selection.
De-register Handsets
You may need to do this if you need to replace a faulty handset. You will need to deregis-
ter all handsets, then re-register each handset individually.
1. Press and hold <PAGE/FLASH> for 10 seconds, until display shows De-register?
(display will show Registering... after approx. 4 seconds; keep pressing the button until
De-register? is displayed) .
2. Press <OK/MENU> to conrm; display shows “Please wait” while de-registration
process is in progress.
Note: Press <CLEAR/MUTE> to return to the previous menu at any time.
Set the Dial Mode
You should normally leave the dialling mode at its default setting of TONE (also called
DTMF) unless the phone is connected to an old exchange that only recognizes
PULSE dialling.
USING YOUR CORDED BASE