Filter
Top Products
d) If this telephone equipment causes harm
to the telephone network, the telephone
company will notify you in advance that
temporary discontinuance of service may be
required. But if advance notice isn’t practi-
cal, the telephone company will notify the
customer as soon as possible. Also, you will
be advised of your right to file a complaint
with the FCC if you believe it is necessary.
e) The telephone company may make
changes in its facilities, equipment, opera-
tions or procedures that could affect the
operation of the equipment. If this happens
the telephone company will provide
advance notice in order for you to make
necessary modifications to maintain
uninterrupted service.
f) If trouble is experienced with this tele-
phone equipment, for repair or warranty
information, please contact Clarity, 1-800-
552-3368. If the equipment is causing harm
to the telephone network, the telephone
company may request that you disconnect
the equipment until the problem is resolved.
g) This telephone equipment is not intended
to be repaired and it contains no repairable
parts. Opening the equipment or any
attempt to perform repairs will void the
warranty. For service or repairs, call 1-800-
552-3368.
h) Connection to party line service is subject
to state tariffs. Contact the state public utility
commission, public service commission or
corporation commission for information.
Regulatory Compliance
E
N
G
L
I
S
H
23
Part 68 of FCC Rules Information
a) This equipment complies with Part 68 of
the FCC rules and the requirements adopted
by the ACTA. On the bottom of this equip-
ment is a label that contains, among other
information, a product identifier in the
format US:AAAEQ##TXXXX. If requested,
this number must be provided to the tele-
phone company.
b) A plug and jack used to connect this
equipment to the premises wiring and
telephone network must comply with the
applicable FCC Part 68 rules and require-
ments adopted by the ACTA. A compliant
telephone cord and modular plug, RJ11C
USOC, is provided with this product. It is
designed to be connected to a compatible
modular jack that is also compliant. See
installation instructions for details.
c) The REN is used to determine the number
of devices that may be connected to a tele-
phone line. Excessive RENs on a telephone
line may result in the devices not ringing in
response to an incoming call. In most but not
all areas, the sum of RENs should not exceed
five (5.0). To be certain of the number of
devices that may be connected to a line, as
determined by the total RENs, contact the
local telephone company. For products
approved after July 23, 2001, the REN for
this product is part of the product identifier
that has the format US:AAAEQ##TXXXX.
The digits represented by ## are the REN
without a decimal point (e.g., 03 is a REN
of 0.3). For earlier products, the REN is
separately shown on the label.
C430Eng_2.6.04 2/7/04 4:39 PM Page 23