Filter
Top Products
Telephone Operations
Placing a Call
1. Press the TALK button (TALK button
will illuminate GREEN) and dial the
number you wish to call.
2. To end the call press the TALK button
or place the handset in the base.
Answering a Call
1. Remove handset from base. You will
automatically be connected.
OR
2. Press the TALK button.
Refer to BOOST Clarity Power and Volume
Control for information on adjusting volume
controls (Page 14).
Temporary Tone
If you have rotary (pulse) dial service, you
can change from pulse to touch tone (tone)
during a call.
1. Make phone call and wait until it
is connected.
2. Press the * key. Keys pressed after
this are sent as tone signals.
3. The phone will automatically reset
to rotary (pulse) service after the
call ends.
Visual Ringers
Visual ringers are located in both the hand-
set antenna and the base of the telephone.
When an incoming call is received, these
lights will flash. The handset visual ringer
will also stay lit while the phone is in use.
Flash
The FLASH button is activated to use custom
calling services such as Call Waiting or
Three Way Calling. Please contact your
local telephone company for information
on these services.
Mute
The MUTE button allows the user to conduct
a private conversation that you do not want
the person on the other end to hear. While
in the mute mode, the MUTE button will illumi-
nate RED and the microphone in the handset
is disabled. Pressing the MUTE button again
will disengage the MUTE feature.
Redial/Pause
The RD/P button operates both the last
number redial and the pause feature.
Last Number Redial:
The last number dialed (up to 32 digits) is
stored in the redial memory until another
number is dialed.
To use this feature:
1. Press the TALK button.
2. When you hear the dial tone,
press the RD/P button.
3. The phone will automatically
dial for you.
Pause Feature:
Programming in a pause will cause the
phone to wait four (4) seconds before
dialing additional numbers. This feature
16
C430Eng_2.6.04 2/7/04 4:39 PM Page 16