Filter
Top Products
Chapter 45 Cisco IP Phone Configuration
Configuring Cisco IPPhones
45-4
Cisco CallManager Administration Guide
OL-5378-01
To display the MAC address when the phone is powered on, refer to the Cisco IP
Phone documentation that supports your phone model. The following examples
show steps that you may perform for the Cisco IP Phone models 12 SP+ and 30
VIP or Cisco VG248 phone ports:
• Cisco IP Phone models 12 SP+ and 30 VIP—Press ** to display the MAC
address on the second line of the LCD display.
• Cisco VG248 phone ports—The MAC address specifies the endpoint from
the Gateway Configuration window of Cisco CallManager Administration.
See the “Gateway Configuration” section on page 44-1 for configuration
information.
Related Topics
• Cisco IP Phone Configuration, page 45-1
• Gateway Configuration, page 44-1
• Adding a Phone, page 45-4
• Updating a Phone, page 45-10
• Cisco IP Phones, Cisco CallManager System Guide
• Phone Configuration Checklist, Cisco CallManager System Guide
Adding a Phone
Before a Cisco IP Phone can be used, you must use this procedure to add the
phone to Cisco CallManager. You can also use this procedure to configure H.323
clients, CTI ports, Cisco ATA 186 telephone adapter, or the Cisco VG248 Analog
Phone Gateway (each of the 48 ports is recognized and configured as a phone).
H.323 clients can be Symbol NetVision phones or Microsoft NetMeeting clients.
CTI ports designate virtual devices that Cisco CallManager applications such as
Cisco SoftPhone and Cisco AutoAttendant use.
Note If you are planning to use a TAPI application to control CTI port devices that are
using the Cisco TAPI Service Provider (TSP), then you may only configure one
line per CTI port device.