Filter
Top Products
Page 5
Factory
Setting
Description of Task Programming Procedure
Programming
Number
Verify Multi-Unit Number
111 #
105
Enable or Disable Anti-Passback
Forgiveness at Midnight
105 # (0 = disable; 1 = enable) #
Change the Visitor Call Response Keys
116
9, 5, 3, 7, 2, 1,
*
Enabled
109
Override Telephone Company
Answering Service
109 # (0 = no; 1 = yes) #
Default is “No”
No
110
111
Dial “0-9” First to Get an Outside Line
Using a Automated Phone System
113 # (0 = disable; 1 = enable) # (0-9, when enabled) #
113
Set a Phone Number's Extension Delay
Time
No Delay
Set Alternative Prefixes
115 # (normal-00, mixed-01, asterisk-02, pound-03,
number-1n) #
each unit in chain must have same setting
115
Normal
Talk through the EL25 Speaker 120 #
120
Cycle Door
121 # (door 1-4) #
121
Latch Door “Open” Until...
122 # (door 1-4) # (end time = hhmm) #
122
Latch Door “Closed” Until...
123 # (door 1-4) # (end time = hhmm) #
123
Release Door “Now”
124 # (door 1-4) #
124
Cycle Relay “Now”
131 # (relay 1-4) #
131
Delete ALL
Directory Codes
201 # 101010 #
201
Delete ALL
Entry Codes
202 # 101010 #
202
Delete ALL
Access Cards
203 # 101010 #
203
Delete ALL
Transmitter Codes
204 # 101010 #
204
Delete ALL
Time Zones
205 # 101010 #
205
Delete ALL
Access Codes from Database
206 # 101010 #
206
To enter programming mode from the EL25:
Press
***
and the 6-Digit Password (2 short beeps will be heard)
Exiting programming mode allows changes to take effect
The Pound Key (#) must be used as Data Field Separator and to Save Data at the end of the sequence.
Time must be entered using a 24-hour format
(8AM=0800, 3PM=1500 etc.
)
2 Short Beeps:
Programming input is valid.
1 Long Beep:
Input is not valid.
If you make an error during an entry, press the asterisk key (
*
) to begin again.
Important:
Optional Steps Indicated with a Background, all other steps are Required
110 # (directory code) # (phone extension delay) #
(call forward extension delay) #
116 # (activate door 1) # (activate door 2) # (activate
door 3) # (activate door 4) # (call wait toggle) #
(extend talk time) # (hang up and deny access) #
Configure “Strikes and Out” Alarm
Feature
104 # (alarm option; 0 = disable, 1 = enable until
relay time expires, 2 = enable until alarm clears) #
(relay group, 0000-1111) #
Order of relays is 4321
104
Disabled
Disabled