Chamberlain EL25 Telephone User Manual


 
Page 20
Entry Codes
Access Cards
1 Press
2 Enter Entry Code (3-9 digits). Then (
#
)
Factory Setting for Entry Code Length is 4 digits
See
“Entry Code Length”
above.
Add an Entry Code
ONLY
. For adding or editing full function Entry Codes (i.e., codes with additional options
such as use schedules, door assignments, etc.).
Note:
A basic Entry Code will be active with the current date, time and never deactivates, unlock all controlled
doors, with no time constraint (i.e., can be used 24 hours a day, 7 days a week).
Example:
Each assigned Entry Code must be entered with the set amount of allowable digits (3-9). For example, if
you assign “4578” as a resident's Entry Code, but the system is set for 5 digits, the visitor will have to enter
“04578” to enter the building.
When adding entry codes, note the following:
Adds Entry Code “5400”.
Then
Entry Codes / Access Cards
Entry Codes / Access Cards
50
Add a Basic Entry Code:
21
Note:
1 Press
2 Enter Card Number (1-65534). Then (
#
)
3 Enter Facility Code (0-63 or 0-255, depending on the card type). Then (
#
)
4 Enter Card Type (26 or 30). Then (
#
)
This programming step allows you to add a card using the card's number. For adding or editing full function
cards (i.e., cards with additional options such as use schedules, door assignments, etc.).
Notes:
A basic card will be active with the current system time and never deactivate, unlock all doors connected
to the EL25, with no time constraint (i.e., can be used 24 hours a day, 7 days a week).
For new records, if you don't add a Facility Code or Card Type, the system will add the defined default values.
Example:
If you don't add a facility code or card type, the system will assign the default. The allowable facility code
range is 0-255 for 26-bit cards and 0-63 for 30-bit cards.
When entering cards with facility codes:
When adding cards, note the following:
Adds card with number “34432”, default Facility Code and 30-bit Card Type.
Then
Enter the facility codes individually when adding cards
OR
Enter a default facility code. If you don't, the card will be assigned the default facility code.
3
4
Add a Basic Card:
80
1 2
Required Step
Optional Step,
Press (
#
) to Skip.
If you make an error during an entry, press the asterisk key (
*
) to begin again.