Filter
Top Products
3 - 7 SETUP SEND
Dual Access (Not available for colour faxes)
You can dial a number, and begin scanning the fax into memory—
even when the MFC is sending from memory or receiving faxes. The
LCD shows the new job number and available memory.
Your MFC normally uses Dual Access. However, to send a
colour fax, the MFC will send the document in real time (even if
Real Time TX
is
Off
).
The number of pages you can scan into the memory will vary
depending on the data that is printed on them.
If you get an
Out of Memory
message while scanning the first
page of a fax, press
Stop/Exit
to cancel scanning. If you get an
Out of Memory
message while scanning a subsequent page,
you can press
Mono Start
to send the pages scanned so far,
or press
Stop/Exit
to cancel the operation.