Filter
Top Products
2. Plug the power adaptor into the mains wall socket and
switch the power on. The green Power light on the base
comes on.
3. Install the 2 x NiMH AAA batteries supplied. Then slide
the battery compartment cover into place.
4. Charge the handset for at least 16 hours by placing the
handset on the base. The red Charging light comes on.
The handset is pre-registered to the base as BT Lyric.
This is shown in the display.
5. After 16 hours charging, plug the telephone line cord
into the wall socket.
Your BT Lyric 1100 is ready for use.
7Getting started
Talk/Standby time
Under ideal conditions, the
handset batteries should give
about 14 hours talk time or 350
hours standby on a single charge.
(The base must still remain
plugged in to the mains and
switched on at all times.)
Please note that new NiMH
batteries do not reach full capacity
until they have been in normal use
for several days.
Battery low warning
When the handset battery symbol
is empty and flashing, and there is
a warning beep every 10 seconds,
you will need to recharge the
handset before using it.
See ‘Battery performance’ on the
following page.
BT Lyric 1100 – 4th Edition – 11th September ’03 – 5358
5358 BT Lyric UG [3] 11/9/03 2:21 PM Page 7