Filter
Top Products
Register handset to base
Make sure the handset is close to the base.
1. At the base: Press and hold until you hear two beeps
(after about 10 seconds). Release .
2. At the handset: Press , then scroll to
Registration
.
Press . Display shows
Base 1-4
. Ticks indicate other
bases the handset is registered to (if any).
3. Enter 1-4 for the base you want to register to followed by
your 4-digit PIN (default 0000). Press .
4. Display shows
Base search 1, 2, 3 4
. The icon
flashes until the handset locates the base.
If the handset does not find the base, it will try to go
back to the previous menu. If this happens, try
registering again using a different base number.
De-register handsets
1. Press then scroll down to
Setup
and press .
2. Scroll down to
Remove HS
and press .
3. Enter your 4-digit PIN (default 0000). Press .
4. Use the and buttons to select the handset (1–5)
you want to de-register. Press .
36 Additional handsets & bases
BT Lyric 1100 – 4th Edition – 11th September ’03 – 5358
Please note
Your handset is supplied pre-
registered as BT Lyric 1 to its base
(Base 1).
Each additional handset you buy
must be registered with the base.
Remember to charge the batteries
of new handsets for at least 16
hours before first use.
If the display shows
Not Sub
, and
(SIGNAL) is flashing, your handset
is not yet registered with the base.
Naming additional handsets
Once you have registered
additional handsets you may wish
to give them a different name, see
page 29.
Please note you cannot de-register
the handset you are using.
5358 BT Lyric UG [4] 12/9/03 2:55 PM Page 36