Filter
Top Products
BT Converse 425 ~ Issue 3 ~ 2nd Edition ~ 23rd July ’03 ~ 5528
1 Install the batteries
The display on your Converse 425 is
powered by 3 x AAA alkaline batteries.
Make sure the phone is
not plugged
into the phone socket. Open the battery
compartment cover.
Insert batteries as shown.
Close the lid and replace the
compartment cover.
5
Plan the location
Situate your Converse 425 close
enough to a phone socket so that the
line cord will reach.
Your Converse 425 can be wall-mounted.
See ‘
Wall-mounting’, on page 20.
Setting up
2 Plug your Converse 425
into the phone socket
SETTING UP
+
+
+
-
-
-
3 Check the dialling mode
Your Converse 425 should be pre-set to
T-TB which gives you TONE dialling.
This ensures the phone will work with
all modern digital exchanges.
If your phone does not work when you
dial a number, try setting the dialling
mode to
T or P.
Note
When your batteries are within about
two weeks of total exhaustion, BATT
LOW will appear in the display. If you
do not replace the batteries and
they become totally discharged your
Converse 425 will not display anything
on the screen.