Filter
Top Products
BT Converse 425 ~ Issue 3 ~ 2nd Edition ~ 23rd July ’03 ~ 5528
20
WALL-MOUNTING
Wall-mounting
1
Unplug and remove the telephone
line cord from the socket on the stand.
2
Unclip the line plug from the
telephone base.
3
Unclip the stand from the base of
the telephone and remove the stand.
4
Reconnect the telephone line to the
line socket on the base of the phone.
5 Drill two holes in the wall 60mm
vertically apart using an 8mm drill bit.
6 Insert the wall plugs if necessary,
then insert the screws leaving about
8mm protruding from the wall on
which to hang the phone.
7
Rotate the handset clip 180˚ so that
it protrudes upward. This holds the
handset in place when wall-mounted.
8
Hang the holes on the back of the
phone over the screwheads and
gently pull the phone downward to
make sure it is securely in place.
9
Hang the handset on the handset clip.
If you need to leave the phone whilst on
a call you can hang the handset on the
park at the top right hand corner of
the product.
Wall
Wall plug
Screw
60mm
60mm
Note
Before you wall-mount your Converse
425 check that:
• you are not drilling into any hidden
wiring
• you do not need the facility of the
data port.
LINEDATA