Filter
Top Products
2. Installation
1. Locating the Base unit
The Base unit should be placed on a level surface, in a position where:
the mains adapter plug will reach an easily accessible 230-V AC
switch mains supply socket - never try to lengthen the mains power cable.
the telephone line cable will reach your telephone line socket or
extension socket.
it is not close to a sink, bath or shower, or anywhere else where it
might get wet.
it is not close to other electrical equipment - fridges, washing
machines, microwave ovens, TVs, fluorescent lights, etc.
2. Plug the coiled handset cord into the Handset. Plug the other end into
the jack on the left side of
the Base unit.
3. Place the Handset in the Base unit.
4. Plug the telephone line cord into the PHONE
LINE jack at the back of the Base unit.
Plug the other end into a
modular wall
jack.
5. Plug the power supply
cord into the POWER
jack at the back of the
Base unit. Plug the
other end to a 230 V
AC, 50 Hz mains
socket, with the switch
on the socket set to
OFF.
6. Switch ON the mains
power at the socket.
7. Lift the Handset and
check for Dial tone
in the earpiece.
Always use the telephone line
cord supplied with your Caprice
600. Other telephone line cords
may not work.
The Caprice 600 Base unit must
be used only with the supplied
mains adapter. Using any other
adapter may damage the unit.
4
Note: The Base unit
does not require a
battery.