Filter
Top Products
6 Maintaining Your System
58 Backup and Restore
Quick Reference Guide
4 Press e to start the restore.
If the system detects an error before beginning the restore, the bottom line
of the display shows one of the following messages:
•
Insert Card or Insert Valid Card
•
Bad File or Bad File-Try Again
•
Incompat Version or Incompatible Versions
•
Empty File
If the system does not detect an error, the restore begins. One of the
following occurs:
• When the restore has completed successfully, the bottom line of the
display shows
Restore Complete for two seconds. Then the system
resets itself.
• If the restore is not successful, the display shows
Restore Failed or
Restore Failed-Try Again for two seconds. All calls in progress are
disconnected and all of the system and telephone programming settings
revert to the factory settings. You are no longer in System Programming
mode. Try the restore again.
• If the date of the file (AUTO. mmddyy or MAN. mmddyy)
indicates that this is not the file you intended to use, see the
instructions packaged with the PC Upgrade card for how to
install the Backup/Restore PC Card.
• If the Backup/Restore PC Card is fresh from the factory, and
no backups have been recorded on it yet, the filenames are
MAN.****** and AUTO.******, respectively. You cannot
use these files for a restore; they generate the error message
Empty File after you press e in Step 4.